As long as the existing garage floor covering is a 2-part resinous product, such as epoxy, polyurea, polyaspartic, or polyurethane, then you should be able to do so. Epoxy coatings usually come in kits with everything you need. Once you choose one, determine if you'll need to order additional supplies. Manufacturers may suggest two coats of epoxy paint and a top coat, but most standard kits only supply enough for one coat.
If you choose to add colored flakes, which will help hide the imperfections inherent in concrete, determine how intensively you will spread them on the floor so as not to fall short. In addition, if the foundations of your garage are raised above ground level at the bottom of the walls, you may want to consider coating the vertical surfaces a few more inches to make it easier to clean the garage. Then decide if you want to include an anti-slip additive, granules that give the finished floor a surface similar to that of sandpaper. This can be a good option in rainy or ice-prone regions.
This DIY garage floor covering application guide is designed as one of the most comprehensive and detailed instruction manuals. Epoxy, as well as other garage floor coverings, are influenced by the weather and can affect cure times, viscosity and adhesion. Unlike the thinner coat of primer, the color coat is a high-density layer, and if you're on the floor too soon, you can leave marks all over the floor. If you don't use these joints or are looking for a seamless garage floor finish, you'll need to pour a freshly mixed batch onto the garage floor just as you finish the back roll of the pre-mixed batch.
The first is that the Behr product is an epoxy paint (not an epoxy coating) and is not designed for transparent coatings. Unfortunately, all manufacturers of easy-to-apply DIY garage floor products market these types of acrylic paints and coatings because they're cheap (relatively speaking), meaning they're quickly leaving the shelves of home improvement centers and hardware stores. Unless you use a water-based epoxy primer that allows it to be applied to wet floors, you'll have to wait a minimum of 24 to 48 hours for the soil to dry completely, sometimes longer if the climate is more humid. Any remaining epoxy left on the floor can be picked up with a wide spatula, a drywall spatula or an old dustpan and placed in the mixing bucket for disposal.
I have a brown epoxy floor (RUSTOLEUM KIT) that is 20 years old. I want to change the color to a high-gloss white epoxy finish. The original transparent sealer has been prepared, sanded and degreased. Shea: I plan to install epoxy floors in a house that I just bought and I have a few questions.
If you're still not sure that your garage floor is sealed and you plan to acid etch the concrete to prepare the surface, apply some acid etching solution to a small area to test it.
Leave Message