Although latex and acrylic latex paints are generally preferred for coating plywood, epoxy floor paint can be used, provided that the applicator employs appropriate preparation and application strategies. Inadequate techniques will ultimately lead to paint failures. Although epoxy floors are most commonly seen in garages, you can also apply epoxy to a wooden floor. In fact, the average homeowner can easily apply epoxy floor coverings to plywood subfloors.
Before trying to paint the wood with an epoxy for garage floors, you should take the following three steps to increase your chances of success. Garage floors that have been smoothed to a smooth surface must be rough to create a texture suitable for painting. When epoxy paint dries, it creates a hard, inflexible surface that protects concrete floors in the garage from damage. Most garage floor paint jobs that fail do so because the surface was prepared incorrectly or because the surface temperature was too low to allow good adhesion.
Below is what the epoxy floor coating looks like after applying the smooth layer and the accent color in the application area and after “turning”. For a successful installation of epoxy floors on wood, you will need to completely fill all the gaps in the subfloor and repair any cracks. Assuming you follow these three steps, you can make your wood more attractive with paint intended for garage floors. How you apply the epoxy floor covering to the wood subfloor will depend on the “look” you are trying to achieve.
After allowing the protective urethane top layer to cure, the installation of the epoxy floor covering on a plywood subfloor is almost finished. As with latex paints for interiors, paint for concrete floors is applied with common brushes and rollers; products sold as single-part epoxy require the same treatment. If your garage floor is stained with oil, grease, and rust, you can easily breathe new life into it with a coat of concrete floor paint. To begin applying the epoxy to the plywood subfloor, start by pouring the smooth layer of epoxy in small areas over the entire application area.
The first step in an epoxy flooring project is to choose the right epoxy system and products for your application. In some cases, the wood doesn't even allow the paint on the garage floor to dry evenly, which could cause the paint to peel off sooner than expected. Although garage floor paint is available in a variety of colors, you may want to choose a light color if you use the garage as a workshop. After you decide which manufacturer of epoxy systems to use, you will need to select the desired epoxy system for your specific application for hardwood floors.
Leave Message